Section views

For Revit users

Moderators: Tim Waldock, monumentum, Toby Maple

Section views

Postby Dan Druff » 14 May 2008, 01:24

I find myself putting in multiple sections, and the bigger the job the more we use most of which are just for a temporary viewing and are not referenced to a sheet which we don’t want to see in printing so I would find it handy to have an option in visibility graphics under annotation categories to have a tick box for “none referenced sections” or something along these lines.

Anyone else think this would be of any use?

Cheers

Rob.
Dan Druff
 

Postby Andrew Munoz » 16 May 2008, 18:46

Take a look in print, settings, setup, under options there is a "Hide unreferenced view tags" check box. Check it and it should do the trick
User avatar
Andrew Munoz
Moderator
 
Posts: 29
Joined: 02 May 2006, 14:14
Location: Sydney
When did you start to use Revit?: v6.0 2003

Re: Section views

Postby simondavid » 10 Aug 2010, 17:49

You could also use a Filter, if your sheet sections had a prefix, you could filter out all other sections from view by name. This cleans up our Drawings while working on them.
simondavid
Quiet member
 
Posts: 2
Joined: 22 Jun 2010, 11:25
Location: Jones Bay Wharf, Pyrmont.
Real Name: Simon David
Company: Greenbox Architecture
When did you start to use Revit?: v9.1 2006


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 3 guests

cron