Printers ??

For Revit users

Moderators: Tim Waldock, monumentum, Toby Maple

Printers ??

Postby RobGod » 01 Apr 2014, 18:27

We are looking at replacing our very old HP Designjet 800 (more than 10 years old) for an new A2 colour printer.
We need it mainly for printing photo and presentation quality prints on to A2 photo paper but it is handy to have as a back up in case our large format OCE CW300 is not working (rarely happens).

I have not started doing any research but am simply looking for some recommendations.
I believe I am likely to start by looking at HP, Oce, Canon and Epson but am open to any suggestions.

- A2 in size (long side of A2, so it is possible to print A1 if required)
- Mainly for glossy prints of renders and presentation boards
- Roll feed is preferred, but sheet feed is also required
- Can act as a back up printer should our main printer be out of action

Hope you can all help...

Regards
Rob
RobGod
Active member
 
Posts: 103
Joined: 08 May 2007, 16:25
Location: Inner West, Sydney
Real Name: Robert Goodall
Company: Nordon Jago Architects
When did you start to use Revit?: v8.0 2005

Re: Printers ??

Postby Lucas Skertchly » 25 Apr 2014, 22:25

Competitively which I have done before the both printers A2 colour printer and HP Designjet 800, I don't feel anything any thing different in both. The all specifications are the same and the only difference is that it is quite old then the new generation printers. Although I would prefer the HP Designjet 800 to the other printers.
Lucas Skertchly
Quiet member
 
Posts: 3
Joined: 25 Apr 2014, 22:10
Real Name: Lucas Skertchly
Company: Retracta Barriers
When did you start to use Revit?: v2013 2012


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest

cron