Sweeping a profile over a DEFINED parabolic curve

Central location for tips developed in other areas in the forums, or gleaned from other sources

Moderator: Tim Waldock

Sweeping a profile over a DEFINED parabolic curve

Postby Moreno » 09 Aug 2012, 07:18

Hi Guys

I'm trying to run a 2D profile on a 3D polyline which is a parabolic curve.

Ive tried doing it as a mass, but when i run the sweep command and select my path, it places the path on the one plane at level 0

Any suggestions, ive attached the 3D polyline for your convenience.

Thanks
Mike
Attachments
3D Track Model.dwg
(356.56 KiB) Downloaded 216 times
Moreno
Quiet member
 
Posts: 1
Joined: 10 Feb 2010, 11:13
Real Name: Michael Moreno
Company: Beca
When did you start to use Revit?: v2009 2008

Re: Sweeping a profile over a DEFINED parabolic curve

Postby corinoco » 13 Sep 2012, 11:57

Revit doesn't much care for splines from other programs...

You will need to either segment your spline to a straight-edge approximation, or try to model your spline natively in Revit.

Revit is not the greatest app for modelling high-fidelity multiple-order complex curves! That said, you should probably try using the 'Adaptive Family' template to create your geometry - you have much more control over complex curves in the 'new' 3D geometry editor than the 'standard' editor.

I have found a straight-edge approximation to be the most efficient method from a time/cost point of view - as long as my sections were correct at grid points, I didn't much care that the intervening straightline sections didn't precisely match the exact shape I wanted. In the end, I didn't even notice the facets when I rendered it, either.

If you're trying to model a boat-hull or aircraft wing though... use Rhino! :D
Adrian Esdaile
Master of the BAN-HAMMER!
Amalgamated Union of Philosophers, Sages, Luminaries and Other Professional Thinking Persons
Sector ZZ9-Plural-Z-Alpha Division

Why not visit the Early Ediacaran on your next holiday? FREE MATRESSES!
User avatar
corinoco
Active member
 
Posts: 81
Joined: 30 Apr 2006, 20:18
Location: Sydney, Australia
Real Name: Adrian Esdaile
Company: Woolworths Limited
When did you start to use Revit?: v4.1 2002


Return to Tips and Tricks

Who is online

Users browsing this forum: No registered users and 1 guest

cron